| Product Name | Commercial Plywood |
|---|---|
| Grade | UTY – UTVC – Regular Back |
| Face & Back Veneer | Okoume / Bintangor |
| Core Veneer | Poplar |
| Glue Type | Type II MR (Moisture Resistance: Interior, Urea Formaldehyde) |
| Thickness | 2.7mm(3ply) / 3.6mm(4ply) / 5.2mm(5ply) / 8mm(7ply)
9mm(7ply) / 12mm(9ply) / 15mm(11ply) / 18mm(13ply) |
| Size(mm) | 1220 x 2440 |
| Live Knots | Yes. |
|---|---|
| Dead Knots | Puttied |
| Knotholes | 25.4mm Max. Diam. Patched, Blending |
| Burls | Yes |
| Color Variation | Yes |
| Stain & Mineral Streak | Yes |
| Dry Pitch & Bark Pockets | Puttied |
| Wormholes, Pinholes | Puttied |
| Worm tracks | Puttied |
| Vane Marks | Yes |
| Cross Breaks | Yes |
| Doze | Puttied |
| Laps | Yes, visible on face& not touchable on face, strongly bonded to avoid delaminating. |
|---|---|
| Voids | Yes, less than 3.0mm, one-two in single layer. |
| Shims | Yes |
| End Split | Yes, not visible on face |
| Uneven Core Thickness | Yes, symmetrically composed |
| Numbers of Components | Not specified |
| Boat or Large symmetrical patches | Yes |
|---|---|
| Live Knots | Yes |
| Dead Knots | Puttied |
| Knotholes | 19mm Max Diam. Puttied, blending |
| Burls | Yes |
| Color Variation | Yes |
| Stain & Mineral Streak | Yes |
| Dry Pitch & Bark Pockets | Puttied |
| Wormholes, Wormtracks | Puttied |
| Vane Marks | Yes |
| Cross Breaks | Yes |
| Doze | Puttied |
| Item | Utility Face Veneer | Not Sanded Back Veneer |
|---|---|---|
| Joint | One is allowed | One is allowed |
| Wrinkles & Delaminating | Not allowed. | Not allowed |
| Open Splits | Hair line | Allowed |
| Filled or Puttied Splits | Three 3.2mm x 305mm | One, max. 9.5mm x 508mm |
| Fill & Putty Smear | Yes | One, max. 9.5mm x 508mm |
| Rough Cut& Ruptured Grain | Yes | Yes |
| Knife Marks | Yes | Yes |
| Tape & Glue Residue | Sanded, Smooth | Yes |
| Sanding | Sanded | Not Sanded |
| Moisture Contents | Less than 13% |
|---|---|
| Adhesion | Resistant 2 hours boiling & 3 hours drying at 60°C |
| Thickness Tolerance | ±0.2mm for 5.5mm & less, ±0.5mm for 6mm & thicker |
| Allowance in width & Length | ±2.0mm |
| Diagonal Allowance | Max. 3.0mm |
| Warp | 0.1% (1.22mm against 1,220mm wide, 2.44mm against 2,440mm long) |